Formwork Sleeves Alu DW 15
- vibrator resistant and non corrosive -
Formwork Sleeve Alu DW15 "short" 15 cms length application for:
slab stopend, trestles and angels, handrail holders

tensile load max. Fh 20 kN/B25/ 8 N/mm2;
max. Fh 39 kN/B25/ 30 N/mm2;
Formwork Sleeve Alu DW15 "long" 19 cms length application for:
supports for climbing formwork, push-pull props
holding down single-sided formwork units

tensile load max. Fh 28 kN/B25/ 8 N/mm2;
max. Fh 54 kN/B25/ 30 N/mm2;
simple assembly :
- Nail on Cone Plug (or Thread Plate) to the formwork element.

- Stick up (or screw on) the Formwork Sleeve.
- Tie it to the reinforcement for optimal stability

- By stripping formwork Cone Plug will be withdrawn,
- Thread Plate remove with a plier or screw driver

The thread rod DW15 now can be screwed into the Formwork Sleeve !
Assembly Plugs - depending on the application of the sleeve
Fixation Plug PVC only for Sleeve "long"
nail on the formwork panel
Cone Plug PVC only for Sleeve "short"
nail on the formwork unit
for concrete cover 12 mms, requested e.g. at exposed concrete components - reusable -
Thread Plate PVC also for Sleeve "short" only
nail on wooden formwork panels or glue on steel formwork sheets - reusable -
Fixation Cone 45° PE
for installing our sleeves DW15 and DW20 at 45°-angularity
Sealing Plug PVC
for sleeves DW15
For exposed concrete construction or required water tightness:
Prefix Cone PE-50 concrete cover 50 mms - reusable -
application for our sleeves DW15 and DW20
Fixation Plug - reusable -
fastening for Prefix Cone PE-50
Concrete-Cone
for sealing the opening when using Prefix Cone
prefabricated concrete product bond in with available
glue products